HLK-W801 Entwicklungsboard WiFi Bluetooth (Pins gelötet)


10,79 € inkl. MwSt. zzgl. 3,99 € Versandkosten

Sofort versandfertig


Das HLK-W801 ist ein leistungsstarkes IoT Entwicklungsboard mit 240Mhz und 2MB Flashspeicher. Es besitzt integrierte Schnittstellen für Wifi, Bluetooth und USB-C.

Der W801-Chip ist ein WiFi-Bluetooth-Dual-Mode-SoC-Chip, er unterstützt WiFi im Stanbard IEEE802.1 1b/g/n und das  BT/BL.E4.2 Bluetooth-Protokoll. Der Chip unterstützt außerdem die TEE-Security-Engine und eine Vielzahl von Hardware-Verschlüsselungs- und -Entschlüsselungsalgorithmen, integrierte DSP-Float-Point-Operationseinheit, Unterstützung der Einstellung der Code-Sicherheitsautorität, Unterstützung der Firmware-Verschlüsselungsspeicherung, Firmware-Signatur, Sicherheits-Debugging, Sicherheits-Upgrade und andere Sicherheitsmaßnahmen zur Gewährleistung der Produktsicherheitsfunktionen.
Es eignet sich für das Internet der Dinge Projekte wie Smart Home, intelligentes Spielzeug, industrielle Steuerung und medizinische Überwachung.

Hinweis: Die Stiftleisten sind fest verlötet.

Details

  • MCU – WinnerMicro W801 32-bit XT804 microcontroller @ 240 MHz with 2MB Flash, 288KB RAM, FPU, DSP, crypto engine, 2.4 GHz radio
  • Connectivity
  • 802.11b/g/n WiFi 4 up to 150 Mbps supporting station, soft AP and station+soft AP modes, WPA2 security
  • Bluetooth 4.2
  • Expansion – 2x 24-pin headers with
  • 1x SDIO host with support for SDIO 2.0, SDHC, MMC 4.2
  • 1x SDIO device up to 200 Mbps
  • Up to 6x UART, 1x I2C
  • 1x SPI slave up to 50 MHz, 1x master/slave SPI
  • LCD controller with support for 4×32 interface
  • 1x I2S
  • Up to 4x ADC (16-bit, 1KHz sampling rate)
  • Up to 44x GPIOs, 5x PWM
  • Up to 15 touch sensors
  • ISO/IEC 7816 smart card interface
  • Reset, Wakeup, 3.3V, and GND signals
  • Debugging – CH340 via USB-C port
  • Misc – Reset and Boot buttons, 7x user LEDs including two connected to PWM capable pins
  • Power Supply – 5V via USB-C port
  • Power consumption – Standby: Less than 10 uA for W801 MCU, not the board itself
  • Dimensions – About 70 x 26 mm

Lieferumfang

  • 1x HLK-W801 Entwicklungsboard WiFi Bluetooth (Pins gelötet)